Isuzu D-Max and Holden Colorado / Rodeo trucks run out of factory camber and caster adjustment when they are lifted. SPC's heavy duty cast replacement arms provide 0° to +4° caster change and ±3° camber change. SPC's patented truck arms offer increased droop travel and free pivoting bushings in an easy to align remove and replace arm. Featuring our long-life maintainable ball joint and SpecRide bushings, this arm is designed to correct alignment angles while maintaining factory ride quality. These remove and replace arms are available in pairs for lifted and off-road applications. Get more droop travel: SPC's arm has improved clearance ot get around the spring bucket when the arm droops, eliminating arm to frame contact on lifted trucks. The maintainable ball joint has an oversized ball and allows more than 80° of articulation to ensure it never binds. SpecRide bushings have free pivot to eliminate any chance of bushing failure seen on many high travel suspensions. Get your drivability back: When you lift your truck you affect caster and camber. SPC's arms have +1° of caster built into them. Using its patented ball joint design the arm will get you 0° to +4° of caster and ±2° of camber. Get your tire where you want it in the wheel well: Use adjustment in the control arm and on the OE lower cams to maximize alignment angles and move oversized tires forward in the wheel well to minimize or avoid fender trimming. Note: This arm set is for international fitments and does not fit North American models. In the Asian region, this arm set fits 2011-2018 Holden Colorado/Rodeo, 2011-2018 Isuzu D-Max. It also fits the 2011-2018 D-Max in the European Regions. All fitments are for both 4WD and RWD models.